For Replacing OEM Ballasts with Aftermarket

OE Ballast to 9006 Adapters


PART #: 2 x H670

[ In Stock: 0 pieces ]

Product Details

Dead Ballast: If you've got a ballast out on your Nissan, Infiniti, Acura, or Honda; buying a new OEM replacement certainly is not cheap!

Custom Setup: If you're doing a quad retrofit on a vehicle with factory HID headlights, these will allow you to run a splitter and relay harness off the factory ballast wiring without any splicing.

No Matter What: We're asking ourselves why we didn't make these sooner! These convenient adapters allow the use of aftermarket parts in place of expensive Original-Equipment ballasts with zero cutting, splicing, or re-wiring involved.

Quality: Made with stranded copper wire, fully sealed male and female connections, and protected with tech-flex mesh in between; these adapters should last longer than your original ballasts did!

Compatibility: Available to fit the OE-side connector on most modern Nissan, Infiniti's, Acura's, and Hondas that use Panasonic/Matsushita Gen III or IV ballasts, or Mitsubishi Electric Gen II or III Ballasts.

Focus: Since 2005, we have focused our efforts on lighting and that's it. Experience means we know the products. We know the technology. We know our competitors, and most importantly, we know our customers. We like to wrench. We like to drive, we like to ride, and like you: we demand the best for whatever it is that gets us going. That's why at LED Concepts; we only stock the shelves with today's best, brightest, and most badass LED Lighting upgrades.

The Details

What you needs to know

  • What's Included

  • Adapters: 2x (One Pair) OE Ballast to 9006 Adapters

  • Warranty: 2 Years

  • Compatibility

  • Honda/Acura: OE HID with Mitsubishi Ballasts

  • Nissan/Infiniti: OE HID with 'Matsushita/Panasonic' Ballasts

  • OTHERS: With Matsushita/Panasonic/Mitsubishi Ballasts

  • OUTPUT: 9006 Female

  • Tech Specs

  • Wire Thickness: 14 AWG

  • Length: Approx. 5.0in / 127mm

  • Insulation: Braided TechFlex